2hrs.
Description
Intergrain Nature’s Timber Oil
is a natural, semi-transparent, penetrating oil designed for use on timber decking and garden furniture. It contains Tung Oil, a natural wood oil that penetrates deep into the timber, providing excellent durability. Comprising 95 percent naturally derived and raw materials from renewable resources,
Nature’s Timber Oil
is fast-drying, allowing application to be completed within one day. It will not crack, peel, or blister as it weathers.
PREPARATION
New timber:
Treat timber with
Intergrain UltraPrep Tannin & Oil Remover
. Then clean with
UltraPrep Timber Cleaner
.
Grey and weathered with no previous coating:
Clean with
UltraPrep Timber Cleaner
. For severely weathered timber, sand back to a fresh surface, remove all sanding dust, then clean with
UltraPrep Timber Cleaner
.
Existing coating in poor condition:
Remove coating by using a combination of
UltraPrep Tannin & Oil Remover
and power washing. Then clean with
UltraPrep Timber Cleaner
.
Paints, varnishes, or coatings in varied condition:For paints, varnishes, or coatings that have deteriorated unevenly, remove all existing coating by using a coatings stripper or sanding back to bare timber. Then clean with
Intergrain UltraPrep Timber Cleaner
.
Important:
If mould is present or if timber is in a mould-prone area, use
Intergrain UltraPrep Mould Killer
to remove surface mould effectively as the first step of preparing the timber for coating.
APPLICATION
1. Stir thoroughly before and during use with a flat blade stirrer.2. If the project requires more than one can of
Nature’s Timber Oil
, mix all cans together in one large container to achieve colour uniformity.3. Apply
Nature’s Timber Oil
using a brush, lambswool applicator, or spray.4. When coating large areas, such as decking and weatherboards, coat no more than three boards at a time. Complete an entire length or continue until a natural break such as a window occurs.5. Wait four hours to dry and apply a second coat. If necessary, sand lightly between coats to remove any raised grain.6. Wait 30 minutes after the second coat is applied and wipe off excess surface oil. Ensure that excess is wiped before the coating gets tacky.7. Do not apply to hot surfaces or those in direct sunlight, as doing so may result in difficult application, poor adhesion, and blistering.8. Do not apply in temperatures above 35°C or below 10°C or if rain or dew is expected within four hours of application.
MAINTENANCE
Conduct a routine 12-monthly maintenance inspection.When timber starts to show signs of dryness and loss of colour, clean timber with
UltraPrep Timber Cleaner
and apply one coat of
Nature’s Timber Oil
, wiping off the surface excess before it gets tacky.
Features
Penetrating oil made from naturally derived, raw materials
Provides excellent durability
Traditional oiled timber finish
