2hrs.
Description
Cabot’s Exterior Varnish Stain
is a combined semi-transparent, water-based stain and varnish that is highly durable and provides protection, colour, and shine without hiding the grain. This product is mould and UV resistant, offering a superior 3-coat system and fast drying, vastly reducing application time. It is ideal for protecting doors, windows, trim, and outdoor furniture.
Preparation – New Bare Timber
To coat new bare timber immediately, scrub damp timber with
Cabot’s New Timber Prep
, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with
Cabot’s Deck Clean
following label instructions. Remove excess water from the surface with a squeegee on
Cabot’s Deck Prep brush
, and allow timber to dry for at least 1 hour. Note: Cooler conditions could slow down the drying time of the timber.
Previously Painted or Varnished Timber
Remove back to bare timber using a paint stripper or sanding. For exterior surfaces, clean with
Cabot’s Deck Clean
following label instructions.
Previously Stained and Oiled Timber
For exterior surfaces, clean with
Cabot’s Deck Clean
following label instructions. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of
Cabot’s Deck Clean
. If water is absorbed into the timber, it is ready for coating. For a more transparent look, sand timber back to bare before coating.
Weathered and Grey Timber
For best results, sand timber back to a fresh substrate. Clean with
Cabot’s Deck Clean
following label instructions.
Application
Apply with a brush or spray applicator.
Stir thoroughly with a broad flat paddle before and during use.
Apply liberally along the length of the timber, including exposed edges and end grain, by brush. The initial milky colour helps with even product application, drying to a semi-transparent finish.
Apply three coats, allowing 2 hours between coats.
Maintenance
Regular inspection of all coated surfaces is recommended. When recoating aged
Cabot’s Exterior Varnish Stain
, if in good condition, lightly sand and clean surfaces, then apply one or more additional coats. If the coating is in poor condition, thoroughly strip the existing coating and prepare as new timber.
Features
Highly durable and weather-resistant
Fast drying, reducing application time
Provides protection, colour, and shine without hiding the grain
